3MFgasket.3mf3MF-Datei · 36,5 KB
↗printables.comAuch auf der Modellbörse – mit Kommentaren, Makes und VariantenLizenz CC BY 4.0
Mirror gasket for Mini El (Spiegelgehäuse) von zapro_2163019 steht unter der Lizenz Creative Commons – Namensnennung 4.0.
This gasket is for the square side mirrors for the Mini-El. It makes sure it doesnt spin around and scratch the hood.
The gasket is held in place with two 10x10mm pieces of double sided foam tape in the two recesses in the bottom of the model.
Affix the model in the angle of your choice and the mirror housing will always sit correct from now on.
Print in TPU with 0.3mm layer height and no supports.
Druckeinstellungen
- Material:
- Schichthöhe:
- Infill:
- Stützstrukturen:
